|
|||||||
|
|
|
|||||
|
|
|||||||
|
|||||||
|
|
|
|||||
|
|
|||||||
Correspondence Page
Just send us an e-mail asking for help, or even better giving myself and other Steamland viewers advice on a topic covered on the site! You can say weather you think me site is good, or even pants...
E-mails sent in by Steamland.com viewers - If you have a question on any subjects covered on this website, send an e-mail to Stephen.newell@btinternet.com
From; "Colin Graham"
Subject; Downside
Fri, 22 Aug 2003 17:21:04 +0100
Do you know the Hornby ID for "Downside". I am hoping to be able to track down this locomotive and it would help if you could supply me with the ID for it.
Cheers Colin
The loco 'Downside' was made by Hornby in a limited edittion pack of just 2000, 'The Kentish Belle'. Therefor the loco will be hard to find and buy. However specialist model dealer located in Alton, Hampshire may be able to aid people where to purchase or even may have some in stock.
Contact; Bob Treacher, Aton Model Centre, 7A Normandy Street, Alton, Hants. GU34 1DD
Tell; 01420 542244
Webmaster
>From: "Wade Anderton"
>To: <stephen.newell@btinternet.com>
>Sent: Monday, January 27, 2003 6:27 PM
>Subject: Re: Mamod steam roller
>
>
> > What do I use to seal the connection to the piston?
> > Thanks,
> > Wade
To seal the connection to the cylinder on any one cylindered Mamod is to use the Lubricant oil provided with the set. Also, tighten the brass screw up as far as it will go to avoid coming lose whilst in steam. This will pull the cylinder up against the 2 brass strips and seal the connection.
Webmaster
Here to help!